
Set Zero band
Set the zero band value of the setpoint comparison. The decimal point is not
necessary because of according to display.
Templete
Command
Reply
S3, [value]
[s 3 A±mm_
Cpt|Lp|
fs
IL
■fj 7\4j 8|%|^|
12.1,7. Related Functions
F-Function
Description
Output Data
f~H0 0 Displayed data
F-HO 1 Gross data
F-HOS
Net data
F~HÜ3 Tare value
F-% H
Gross data / Net data / Tare value
Output mode
F-Funciion
Description
Stream mode
F-HIÜ
Description of “Stream Mode“ at page 31
Auto print mode F-% 1
Description of "Auto Print Mode" at page 31
Manual print mode
F~^[j 3
When pressing the print key each time, the data is output once.
Command mode
(no address)
F-%3
Refer to "12.1.3.Command Format" of RS-232C interface.
Command mode
with address
Auto-print condition
F-Function
Description
Positive data only
F-H3 0
"inhibition regiori of output" ^*f5d.
-1-5D < "permission region of output".
Positive and
negative data
F-% 1
-5d ^ "inhibition region of output" S -fSd.
"Permission region of output" < -5d, +5d < "permission region of output".
F"Function
Description
Delay for continual
data
F-%ü
Not used
F-% 1 Approximately 2 seconds
Baud rate 600 bps, 1200 bps, 2400 bps, 4800 bps, 9600 bps
Data format
F-HS
Referto "12.1.2.Data Format" of RS-232C interface.
F-%
Address
BO to
33
Factory setting is BB,
When F-H1 H is not selected, f-% is ineffective.
CF-Functlon
Description
[F-Bl Data output of tare
[F-B8 Output on over load and unstable state.
Use or not used
[F-B3 Format of Header Selection of TR, PT, GS, NT, T, G and N
lF- IB Figure number of unit, decimal point
Two figures or three figures, dot or comma
[F- II Accumulation function Effective or ineffective
AD-4329 Weighing Indicator
Page 49
12. RS-232C Interface
Comentarios a estos manuales